The Band strap can be replaced when you want to clean it or switch to another size or colour. The strap attaches to the main device using plastic holders that slide into grooves on the device housing.
Before You Start
- Work on a clean, flat surface.
- Make sure your Band is powered off.
- Ensure your hands and the device are clean and dry.
To Remove the Strap
- Locate the plastic holders on both sides of the strap.
- Hold the device firmly and gently pull the strap holder outward from the groove.
- Repeat on the other side to fully detach the strap.
- Inspect the grooves and holders to ensure they're clean before attaching a new strap.
To Attach a New Strap
- Align the plastic holder on one end of the new strap with the groove on the device housing.
- Slide the holder into the groove until it sits securely — it should fit smoothly without gaps or movement.
- Repeat for the other side.
- Double-check that both sides are firmly seated and cannot slide out easily.
Orientation Note
- When wearing on your left wrist: the button should face outward on the left side of the device.
- When wearing on your right wrist: the button should face outward on the right side of the device.
Tip: This ensures proper sensor alignment and comfortable access to the button.
To Wear and Secure
- Slide your wrist through the strap loop.
- Pull the loose end to adjust the fit — snug but not tight.
- Fold the strap back through the loop holder and fasten with the Velcro closure.
- Ensure the sensors on the underside make good, even contact with your skin.
🏳️ Hardware Specifications